Numerical and analytical investigation of steel beam subjected to four-point bending

F.M. Farida; A. Surahman; A. Sofwan

doi:10.1088/1757-899X/316/1/012032

← Back to search

Numerical and analytical investigation of steel beam subjected to four-point bending

Open

F.M. Farida, A. Surahman, A. Sofwan

2018 IOP Conference Series: Materials Science and Engineering Vol. 316 Issue 1 Conference paper Cited by 1 SDG 7SDG 16

Abstract

A One type of bending tests is four-point bending test. The aim of this test is to investigate the properties and behavior of materials with structural applications. This study uses numerical and analytical studies. Results from both of these studies help to improve in experimental works. The purpose of this study is to predict steel beam behavior subjected to four-point bending test. This study intension is to analyze flexural beam subjected to four-point bending prior to experimental work. Main results of this research are location of strain gauge and LVDT on steel beam based on numerical study, manual calculation, and analytical study. Analytical study uses linear elasticity theory of solid objects. This study results is position of strain gauge and LVDT. Strain gauge is located between two concentrated loads at the top beam and bottom beam. LVDT is located between two concentrated loads. © Published under licence by IOP Publishing Ltd.

Affiliations

Civil Engineering Department, Civil Engineering and Environmental Faculty, Institut Teknologi Bandung, Bandung, 40132, Indonesia; Civil Engineering Department, Engineering Faculty, Universitas Negeri Jakarta, Jakarta, 13220, Indonesia; Engineering Division, P.T. LAPI, Institut Teknologi Bandung, Bandung, 40132, Indonesia

View full text (DOI) →

Research at a Glance

Research at a Glance

Topics & SDG Alignment

Collaboration

Author Profile (Selected)

References Overview

Journal & Source

Metadata & Integrity